3-56 ENGINE
The followings are reminders for piston installation:
• Before installing the piston pin, apply molybdenum oil solution
onto its surface.
• Apply engine oil to the big and small ends of the conrod.
• Place a clean rag over the cylinder base to prevent the piston
pin circlip from dropping into crankcase. Install the piston pin
circlip
1
.
.
(
MOLYBDENUM OIL SOLUTION
#
• Install the piston with the arrow mark
2
facing towards the
exhaust side.
CYLINDER
Before installing the cylinder, oil the big and small ends of the
conrod and also the sliding surface of the piston.
• Install the dowel pins into the crankcase and then install the
cylinder gasket
1
.
#
• Make sure that the piston rings are properly positioned, and
insert the piston into the cylinder.
NOTE:
When mounting the cylinder, keep the cam chain taut. The cam
chain must not be caught between the cam chain drive sprocket
and crankcase when crankshaft is rotated.
• Temporarily tighten the cylinder base nuts.
• Install the cam chain guide
2
.
Use a new piston pin circlip
1
to prevent circlip fail-
ure.
Use a new gasket to prevent oil leakage.
Summary of Contents for DR 125
Page 1: ...DR Z125 L 9 9 5 0 0 4 1 1 2 5 0 1 E...
Page 34: ...PERIODIC MAINTENANCE 2 21...
Page 167: ...SERVICING INFORMATION 7 9 WIRING DIAGRAM...
Page 222: ...Printed in Japan K3 K4 K5 K6 K7 K8...