ENGINE 3-53
• Install the clutch sleeve hub nut, and tighten it to the specified
torque with the special tool.
!
Clutch sleeve hub nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
"
09920-53740: Clutch sleeve hub holder
• Bend the lock washer
1
securely.
• Install the clutch push rod
2
as shown in the illustration.
A
Push piece side
• Apply engine oil to the bearing.
• Install the push piece
3
, bearing
4
and washer
5
.
• Install the clutch drive and driven plates one by one into the
clutch sleeve hub.
• Install the clutch pressure plate
6
, clutch springs and clutch
spring mounting bolts.
• Hold the generator rotor nut and tighten the clutch spring
mounting bolts in a crisscross pattern.
NOTE:
Make sure that the clutch pressure plate is installed correctly.
• Loosen the locknut
7
, and turn in the release screw
8
to feel
resistance.
• From that position, turn out the release screw
8
1/4 turn, and
tighten the lock nut
7
by holding the release screw
8
.
Summary of Contents for DR 125
Page 1: ...DR Z125 L 9 9 5 0 0 4 1 1 2 5 0 1 E...
Page 34: ...PERIODIC MAINTENANCE 2 21...
Page 167: ...SERVICING INFORMATION 7 9 WIRING DIAGRAM...
Page 222: ...Printed in Japan K3 K4 K5 K6 K7 K8...
