Suzuki Burgman AN400, Service Manual, Page: 370 / 475

4C-5 Rear Brakes:
3) Remove the piston (back side) with turning
counterclockwise.
4) Remove the dust seals (3) and piston seals (4) from
the cylinder.
CAUTION
!
• Use care not to cause scratch on the
cylinder bore.
• Do not reuse the piston seal and dust seal
that have been removed.
5) Remove the brake-lock housing bolt and brake-lock
housing (5).
6) Remove the lock-nut (6), adjuster (7), arm (8) and
brake-lock shaft (9).
Assembly
Assemble the caliper in the reverse order of
disassembly. Pay attention to the following points:
• Assemble the gasket (1).
CAUTION
!
Replace the gasket with a new one.
• Apply thread lock to the brake-lock housing bolts (2)
and tighten them to the specified torque.
: Thread lock cement 99000–32130
(THREAD LOCK CEMENT SUPER 1360 or
equivalent)
Tightening torque
Brake-lock housing bolt (a): 22 N·m (2.2 kgf-m,
16.0 lb-ft)
I705H1430011-01
3
4
I705H1430012-02
5
I705H1430013-02
6
7
8
9
I705H1430014-01
1
I705H1430015-01
(a)
2
I705H1430017-04