Suzuki Burgman AN400, Service Manual

Page: 263 / 475

Starting System: 1I-8
4) Connect the side-stand switch coupler.
5) Install the left footboard. Refer to “Footboard
Removal and Installation in Section 9D (Page9D-
21)”.
Turn Signal / Side-stand Relay
The turn signal/side-stand relay is composed of the turn
signal relay, side-stand relay and diode.
Side-stand relay
1) Remove the turn signal/side-stand relay. Refer to
“Turn Signal / Side-stand Relay Removal and
Installation (Page1I-7)”.
2) Check the insulation between “D” and “E” terminals
using the multi-circuit tester.
3) Apply 12 V to terminals “D” and “C” ((+) to “D” and (–
) to “C”) and check the continuity between “D” and
“E”. If there is no continuity, replace the turn signal/
side-stand relay with a new one. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page1I-7)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
)
4) Install the turn signal/side-stand relay. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page1I-7)”.
Diode inspection
1) Remove the turn signal/side-stand relay. Refer to
“Turn Signal / Side-stand Relay Removal and
Installation (Page1I-7)”.
2) Measure the voltage between the terminals using the
multi-circuit tester.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test (
)
NOTE
If the multi circuit tester reads 1.4 V and
below when the tester probes are not
connected, replace its battery.
3) Install the turn signal/side-stand relay. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page1I-7)”.
I649G1190027-01
DIODE
SIDE-STAND RELAY
TURN
SIGNAL
RELAY
“A” “B” “C” “D”
“E” “F” “G”
“A” “B” “C” “D” “E” “F” “G”
I649G1190028-01
“A”
“B” “C” “A”
“B”
“C”
I649G1190029-01
+
Probe of tester to:
“A”
“A” “C” “B”,
“C” “B”,
– 0.4 0.6 V
1.4 V and more
(Tester's battery voltage)
-
Probe of
tester to:
I649G1190046-03