Suzuki Burgman AN400, Service Manual

Page: 223 / 475

Engine Cooling System: 1F-12
Installation
Install the thermostat in the reverse order of removal.
Pay attention to the following points:
• Apply engine coolant to the rubber seal around the
thermostat.
• Position the thermostat with one of the air bleeder
hole “A” upside.
• Pour engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page0B-11)”.
• Bleed air from the cooling circuit. Refer to “Cooling
System Inspection in Section 0B (Page0B-11)”.
Thermostat Inspection
B705H11606018
Inspect the thermostat in the following procedures:
1) Remove the thermostat. Refer to “Thermostat
Removal and Installation (Page1F-11)”.
2) Inspect the thermostat pellet for signs of cracking.
3) Test the thermostat at the bench for control action.
CAUTION
!
• Do not contact the thermostat (1) and the
column thermometer (2) with a pan.
• As the thermostat operating response to
water temperature change is gradual, do
not raise water temperature too quickly.
• The thermostat with its valve open even
slightly under normal temperature must be
replaced.
4) Immerse the thermostat (1) in the water contained in
a beaker and note that the immersed thermostat is in
suspension.
5) Heat the water by placing the beaker on a stove and
observe the rising temperature on a thermometer
(2).
6) Read the thermometer just when opening the
thermostat. If this reading, which is the temperature
level at which the thermostat valve begins to open, is
out of the standard value, replace the thermostat
with a new one.
Thermostat valve opening temperature
Standard: Approx. 82
°
C (180
°
F)
7) Keep on heating the water to raise its temperature.
Just when the water temperature reaches specified
value, the thermostat valve should have lifted by at
least 3 mm (0.12 in). A thermostat failing to satisfy
either of the two requirements (start-to-open
temperature and valve lift) must be replaced.
Thermostat valve lift “a”
Standard: 3 mm and over at 95
°
C (0.12 in and
over at 203
°
F)
8) Install the thermostat. Refer to “Thermostat Removal
and Installation (Page1F-11)”.
“A”
I705H1160028-01
I705H1160029-01
“A”: String “B”: Water
I705H1160030-03
I705H1160031-04