Suzuki Burgman AN400, Service Manual

Page: 275 / 475

Charging System: 1J-8
Battery Components
B705H11A06011
Battery Initial Charging
B705H11A06007
Filling Electrolyte
1) Remove the aluminum tape (1) which seals the
battery filler holes (2).
2) Remove the caps (3) from the electrolyte container.
NOTE
• Do not remove or pierce the sealed areas
(4) of the electrolyte container.
• After completely filling the battery with
electrolyte, use the caps (3) from the
electrolyte container to seal the battery
filler holes.
3) Insert the nozzles of the electrolyte container (5) into
the electrolyte filler holes of the battery.
4) Hold the electrolyte container firmly so that it does
not fall.
5) Do not allow any of the electrolyte to spill.
6) Make sure the air bubbles (6) rise to the top of each
electrolyte container and leave the electrolyte
container in this position for more than 20 minutes.
NOTE
If air bubbles do not rise from any one of the
filler ports, tap the bottom of the electrolyte
container two or three times.
Never remove the electrolyte container from
the battery while there is still electrolyte in
the container.
1. Upper cover breather 5. Terminal
2. Cathode plates 6. Safety valve
3. Stopper 7. Anode plates
4. Filter 8. Separator (Fiberglass)
2
1
3
5
6
7
8
4
I705H11A0020-01
2
1
I705H11A0021-01
3
4
I705H11A0022-01
5
I705H11A0023-01
6
I705H11A0024-04
I310G11A0024-01