34
PROGRAMMING MODES 26, 27, 29 and 30
Mode 26 Erase Event Buffer
To erase the system’s event buffer, activate Mode 26:
• With the system in the “Arm/Disarm” mode, enter [*][26].
• The “Ready” light will FLASH; enter the Installer’s Code.
• The “Ready” light will be shut OFF and the “Program” light will FLASH.
• Press [1] to erase the event buffer, or press any other key to return to the “Arm/Disarm” mode.
• After [1] is pressed, the “Memory” light will FLASH. When the event buffer is cleared, the keypad will sound a series
of beeps and the system will return to the “Arm/Disarm” mode.
Mode 27 Print Installer’s Programming
Mode 27 may be used to print all programming in Modes 20 through 23.
• With the system in the “Arm/Disarm” mode, enter [*][27].
• The “Ready” light will FLASH; enter the Installer’s Code.
• The “Ready” and “Program” lights will come ON and the “Memory” light will FLASH.
• Enter a number from 20 through 23 to select which Programming Mode to print.
• When the Programming Mode to be printed is entered, the system will begin to print all programming in that mode.
When printed is completed, the system will return to the “Arm/Disarm” mode.
NOTE: If an alarm occurs during printing, the system will cancel the Programming Mode printout if the alarm is
programmed to be sent to the local printer.
Mode 29 Installer Messages
Preprogrammed messages can be “sent” to the monitoring station to indicate that the Installer is on the premises
or that service is in progress. The messages are actually programmed at the monitoring station, and the control
panel simply sends 2-digit codes to indicate which message should be displayed or printed. Up to 16 messages
may be used
• With the system in the “Arm/Disarm” mode, enter [*][29].
• The “Ready” light will FLASH; enter the Installer’s Code.
• The “Ready” light will be shut OFF, the “Program” light will come ON, and the “Memory” light will FLASH.
• Enter a number from 01 to 16 to select the message to printed at the monitoring station. After a 2-digit number
is entered, the system will return to the “Arm/Disarm” mode.
Mode 30 Restore Factory Default Programming
• With the system in the “Arm/Disarm” mode, enter [*][30].
• The “Ready” light will FLASH; enter the Installer’s Code.
Refer to Restoring The Factory Program for instructions on how to restore the system’s programming to the factory
default settings.
firealarmresources.com
firealarmresources.com
