11
Entering Hexadecimal Numbers
Some Installer Programming Sections require that hexadecimal (base 16) numbers be entered. To enter the hex
numbers A through F, two keys on the Keypad are pressed at the same time, as described below:
For hex number...
Press...
A ..................... 1 and 2 keys simultaneously
B ..................... 2 and 3 keys simultaneously
C ..................... 4 and 5 keys simultaneously
D ..................... 5 and 6 keys simultaneously
E ..................... 7 and 8 keys simultaneously
F ..................... 8 and 9 keys simultaneously
Programming the Panel
Install the control panel and make the wiring connections as described in the Installation section of this manual.
Apply power to the panel and program the system as described in the Programming Section of this panel. When
programming is complete, test the system to ensure that all programmed functions work properly.
Programming and the Memory Security Jumper
If the Memory Security Feature is enabled (Mode 22 Address [003], Light 4), the pins marked “LK6” must be
shorted using a plug-in jumper. If the pins are not shorted, the control panel will not allow any Installer
Programming to be performed. Note that the jumper must be removed after Installer Programming is complete.
PROGRAMMING SECTIONS
A
C
E
B
D
F
firealarmresources.com
firealarmresources.com
