12
PROGRAMMING SECTIONS
Restoring The Factory Default Program
In the event that the Installer’s Code is erased through an error in programming, it is possible to restore the panel’s
factory default program.
1 Remove all power from control panel
2 Using a jumper, short the pins marked “LK6”
3 Apply power to the control panel
4 The “Program”, “Ready”, “Armed” and “Bypass” lights will flash.
• Enter a number on the Keypad, the press the the [
∗
] Key. This selects the item or group of items that will
be restored to the factory default program. Enter a number from the list below:
Press...
Items to Restore to Default
Indicated by...
0
All data
Zone Lights 1 through 8
1
Master Code only
Zone Light 1
2
Access Codes only
Zone Light 2
3
For Future Use
Zone Light 3
4
For Future Use
Zone Light 4
5
All Reporting Data
Zone Light 5
6
For Future Use
Zone Light 6
7
Group Data (Zones and Access Code assignments)
Zone Light 7
8
Zone Types
Zone Light 8
9
All items in Options 5 through 8
Zone Lights 5 through 8
After a number from 0 to 9 is pressed, press [
∗
] to enter the selection.
• The “Memory” light will flash after the [
∗
] Key is pressed. When the “Memory” light stops flashing, the
selected items have been restored to their factory settings. Select another programming function or press [#]
to exit.
WARNING: If Mode 22 Address 004 Light 2 has been selected, the default Installer’s Code will not be restored by
the method described above. This feature is designed to prevent an unauthorised person from restoring
the factory default programming and then using the default Installer’s Code to reprogram the panel.
Contact your Sur-Gard distributor for more information.
NOTE: The factory default program may also be restored by entering Mode 30.
Entering Installer Programming Modes
1 Press the [
∗
] key
2 The “Program” light will flash.
3 Enter two digits to access the desired mode. For example, press [2][0] to enter Mode 20.
4 The “Ready” light will flash and the “Program” light will be steadily illuminated.
5 Enter the Installer’s Code
6 The “Memory” light will flash and the “Program” and “Ready” lights will be steadily illuminated. This indicates
that the DV8000 is now waiting for an Address to be entered.
7 Enter three digits to access the desired address. For example, press [0][2][0] to enter Address [020]. The
“Memory” light will be steadily illuminated and the Zone Lights will indicate the data presently programmed at
the Address.
Keypad Editing Commands
Several keypad commands are available when editing the Installer’s Programming:
Function
Press...
Advance to next Address
[
∗
]
Return to previous Address
[
∗
] and [#] together
Go to a new Address
[#] then enter the Address Number
Exit Programming Mode
[#] then [#] again
Scroll one digit right
[0] and [#] together
Scroll one digit left
[
∗
] and [0] together
firealarmresources.com
firealarmresources.com
