Chapter 2: Installation
2-3
alignment notch in the SEC cartridge fits over the plug in Slot 1. Push the
processor down firmly, with even pressure on both sides of the top, until it
is seated.
Figure 2-2. Retention Mechanism
Top of Processor
B
C
A
Do not screw too tightly!
6. Slide the clips on the supports (A) forward until they click into place to
hold the pegs securely. Apply slight pressure on the peg and push the peg
toward the clip while pushing the clip forward. Push the latches on the
processor (B) outward until they click into place in the retention mechanism.
The latches must be secured for proper electrical connection of the proces-
sor.
7. Attach the small end of the power cable (C in Figure 2-3) to the three-
pin connector on the processor, then attach the large end to the three-pin
connector on the motherboard.
Summary of Contents for SUPER P6DBE
Page 12: ...Chapter 1 Introduction 1 3 Notes...
Page 38: ...Chapter 1 Introduction 1 29...
