Supero SUPER P3TDL3, User Manual

Page: 40 / 96

2-16
S
UPER P3TDL3/P3TDLE User’s Manual
3rd Power Supply Failure
Alarm
If enabled, the system will notify
you in the event of a power sup-
ply failure. This feature assumes
that three power supply units are
installed in the chassis, with one
acting as a backup. If you only
have one or two power supply
units installed, you should disable
JP12 to prevent false alarms. See
Table 2-31 for jumper settings.
(For Supermicro hot-swap triple
redundant power supplies only.)
Onboard LAN/NIC
Enable/Disable
Change the setting of jumper JP8
to enable or disable the onboard
LAN or NIC (Network Interface
Card) on your motherboard. See
Table 2-30 for jumper settings.
Overheat Alarm (Buzzer)
Enable/Disable
You may want to disable the audio
alarm signal that notifies you of
overheat condtions. Jumper JP7
gives you this option. See Table
2-29 for jumper settings.
J u m p e r
P o s itio n
O p e n
C lo s e d
D e fin itio n
D is a b le d
E n a b le d
T a b le 2 -2 9
O v e rh e a t Alarm
E n a b le /D is a b le
J u m p e r S e tting s (J P 7 )
J u m p e r
P o s itio n
O p e n
C lo s e d
D e fin itio n
E n a b le d
D is a b le d
T a b le 2 -3 0
O n b o a rd L AN /N IC
E n a b le /D is a b le
J u m p e r S e tting s (J P 8 )
J u m p e r
P o s itio n
O p e n
C lo s e d
D e fin itio n
D is a b le d
E n a b le d
T a b le 2 -3 1
P o w e r S u p p ly F a ilu re
Ala rm E n a b le /D is a b le
J u m p e r S e ttin g s (J P 1 2 )
Watchdog Reset
Jumper JP14 allows you to enable
or disable the Watchdog feature.
The normal (default) position is
o p e n t o d i s a b l e t h e w a t c h d o g
timer. See Table 2-32 for jumper
settings.
J u m p e r
P o s itio n
O p e n
C lo s e d
D e fin itio n
D is a b le d
E n a b le d
T a b le 2 -3 2
W a tc h d o g
E n a b le /D is a b le
J u m p e r S e tting s (J P 1 4 )