Supero SUPER P3TDL3, User Manual

Page: 28 / 96

2-4
S
UPER P3TDL3/P3TDLE User’s Manual
Figure 2-4. Side View of DIMM Installation into Slot
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the two notches.
N o t e : N o t c h e s
s h o u ld a lig n
w ith th e
r e c e p t i v e p o i n ts
o n t h e s lo t
D IM M S lo t
D IM M
N o tc h e s N o tc h e s
2-4 Installing DIMMs
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
NOTE: Check the Supermicro web site for recommended memory
modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
DIMM Installation (See Figure 2-4)
1. Insert DIMMs as required for the desired system memory.
2. Insert each DIMM module vertically into its slot. Pay attention to the
two notches along the bottom of the module to prevent inserting the
DIMM module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot.
4. Start DIMM insertion at the DIMM0 slot and continue numerically
through the DIMM3 slot, as needed.
Support
The P3TDL3/P3TDLE supports only registered ECC PC100 and PC133
SDRAM. Note that the memory and front side bus speeds are synchro-
nized, meaning if PC133 is used with a 100 MHz FSB, the memory will
run at 100 MHz.