Supero SC848 Series, User Manual

Page: 63 / 124

4-25
Chapter 4 Chassis Setup and Maintenance
Removing the Peripheral Drawer
After selecting the optimal configuration options for your system, follow the instruc -
tions below to assemble the peripheral drawer with the options desired.
Opening the Peripheral Drawer
1. Power down the system, unplug the cords from the back of the power sup-
plies and remove the chassis top cover.
2. Unplug the fan cables from the motherboard if necessary, and then remove
the middle bracket (See page 4-7)
3. Disconnect the existing power and data cables which extend from the periph-
eral drawer to other system components (Including the motherboard and the
power distributor board).
4. Reach beneath the underside of the chassis floor. Pull the peripheral drawer
release button while simultaneously using the other fingers to push the back
of the peripheral drawer forward and out of the chassis.
CAUTION! Cable lengths in the peripheral drawer only permit the tray to
extend half-way open to allow replacement of the peripheral devices. When
configuring HDDs, all cables connecting to the drawer must be removed from
the motherboard and the power distributor board, before fully extending the
drawer and removing it from the chassis.
Release Button on Inside
of Drawer Extension
Figure 4-33: Peripheral Device Release Latches
Release
Button