Supero FatTwin F627R2-F73, User Manual

Page: 99 / 144

Chapter 6: Advanced Chassis Setup
6-15
1
5
1
6
Assembling the PCIE Slot Bracket Assembly
Each node supports one expansion card. This expansion card must be plugged into
a riser card, which in turn plugs into the motherboard.
Assembling the PCIE Slot Bracket Assembly
1. Power down the system and remove the power cords from the rear of the
power supplies as described in Section 6-3. Remove the node from the
chassis as described in Section 6-5 and remove the cover from the node as
described in Section 6-6.
2. Open the PCIE slot clip and remove the PCIE slot shield.
3. Remove the mounting screw which secures the PCIE slot cover in the PCIE
slot and set this aside for later use.
4. Remove the PCIE slot cover by sliding it upward and out of the PCIE slot.
5. Remove the screws securing the riser card bracket to the chassis and set
them aside for later use.
6. Lift the riser card bracket up and out of the chassis.
Figure 6-12: Installing the Riser Card and Bracket
1
3