Supero FatTwin F627R2-F73, User Manual

Page: 75 / 144

Chapter 5: Advanced Motherboard Setup
5-21
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that will reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate a
non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
VGA Enable (JPG1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
BMC Enable (JPB1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Normal
I2C to PCI-Exp (JI2C1/JI2C2)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)
GLAN Enable/Disable
JPL1 enables or disables the LAN Port1/
LAN Port2 on the motherboard. See the
table on the right for jumper settings. The
default setting is Enabled.
GLAN Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable
t h e e m b e d d e d B M C ( B a s e b o a r d
Management) Controller to provide IPMI
2.0/KVM support on the motherboard.
See the table on the right for jumper
settings.
I2C Bus to PCI-Exp. Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to
connect the System Management Bus
(I
2
C) to PCI-Express slots. The default
setting is Open to disable the connection.
See the table on the right for jumper
settings.