SuperServer 8049U-E1CR4T User's Manual
30
Chapter 3
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and part
numbers given.
Remove power from the system before installing or replacing components. Refer to Section
3.1.
3.1 Removing Power
Use the following procedure to verify that power has been removed from the system. This
step is required when removing or installing non hot-swap components or when replacing a
non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has fully shut down, disconnect the AC power cord(s) from the power
strip or outlet. (If your system has more than one power supply, remove the AC power
cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Accessing the System
Two top covers are removable to allow access to the inside of the chassis.
Removing the Mid-Top Cover
1. Pinch the release tabs.
2.
Slide the cover forward to disengage the rear tabs and lift it off.
Removing the Rear-Top Cover
•
Remove the screws securing the cover to the chassis and lift it off.
Warning
: Except for short periods of time, do not operate the server without the cover in place.
The chassis cover must be in place to allow for proper airflow and to prevent overheating.
Summary of Contents for SuperServer 8049U-E1CR4T
