Chapter 2: Server Installation
21
Warning:
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing. Failure to
stabilize the rack can cause the rack to tip over.
Figure 2-3. Assembling the Outer Rails
Installing the Outer Rails onto the Rack
Installing the Outer Rails
1. Attach the short bracket to the outside of the long bracket. Align the pins with the slides
and verify that both bracket ends face the same direction.
2.
Adjust the short and long brackets to the proper distance so that the rail fits snugly into
the rack.
3. Secure the long bracket to the front of the outer rail with two screws and washers, and
secure the short bracket to the rear of the outer rail with three screws and washers.
4. Repeat steps 1-3 for the second outer rail.
Secure to
Front of Rack
Secure to
Rear of Rack
Fixed Pins
Attach Outer
Rails Together
1
1
Summary of Contents for SuperServer 8049U-E1CR4T
