Supermicro SuperServer 5035L-I, User Manual

Page: 46 / 82

6-2
S
UPER
S
ERVER 5035L-I User's Manual
6-2 Front Control Panel
The front control panel must be connected to the JF1 connector on the motherboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection. Connect the cable from JF1 on the
motherboard (making sure the red wire plugs into pin 1) to the appropriate comn-
nector on the front control panel PCB (printed circuit board). Pull all excess cabling
over to the control panel side of the chassis.
The LEDs inform you of system status - see Figure 6-1 for details. See Chapter 5
for details on JF1.
Figure 6-1. Front Control Panel LEDs
NIC
HDD
Overheat
Power On
Indicates network activity the GLAN port.
Indicates SATA hard disk/CD-ROM drive activity.
Indicates an overheat condition or fan failure.
Indicates the system is powered on.