Supermicro SuperServer 5035L-I, User Manual

Page: 27 / 82

Chapter 5: Advanced Motherboard Setup
5-3
should take care to keep them routed as they were originally after reconnecting
them (make sure the red wires connect to the pin 1 locations). The following data
cables (with their locations noted) should be connected. (See the layout on page
5-9 for connector locations.)
SATA drive data cable (I-SATA0 ~ I-SATA3)
•
Control Panel cable (JF1)
•
Important! Make sure the the cables do not come into contact with the fans.
Connecting Power Cables
The X7SLM-L has a 24-pin primary power supply connector (JPW1) for connection
to the ATX power supply. In addition, an 8-pin processor power connector (JPW2)
must also be connected to your power supply. See Section 5-9 for power connec-
tor pin defi nitions.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
All JF1 wires have been bundled into a single ribbon cable to simplify this connec-
tion. Make sure the red wire plugs into pin 1 as marked on the board. The other
end connects to the Control Panel PCB board, located just behind the system status
LEDs on the chassis. See Chapter 5 for details and pin descriptions.
Figure 5-1. Control Panel Header Pins
NMI
x (Key)
Vcc
Vcc
Vcc
Vcc
Vcc
Vcc
Reset (Button)
Power (Button)
Ground
x (Key)
Power On LED
HDD LED
NIC1 LED
NIC2 LED
OH/Fan Fail LED
Power Fail LED
Ground
Ground
2 1
20 19