Supermicro SuperServer 5035L-I, User Manual

Page: 32 / 82

5-8
S
UPER
S
ERVER 5035L-I User's Manual
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Memory Support
The X7SLM-L supports up to 2GB unbuffered non-ECC DDR2 667/533/400 in 2
DIMM slots. Populating these DIMM modules with a pair of memory modules of
the same type and same size will result in interleaved memory, which will improve
memory performance.
5-7 Installing PCI Add-On Cards
The 5035L-I can accommodate standard size add-on cards in all slots on the
X7SLM-L motherboard.
Installing Add-on Cards
Depress the release latch (A) that holds the protective bracket (B), which 1.
secures the add-on card brackets to the chassis.
Lower the protective bracket from over the top of the add-on card dummy 2.
brackets as shown in the lower illustration.
Remove the add-on card dummy brackets from their slots. 3.
Simultaneously, slide the add-on card and its bracket into the slot on the 4.
chassis, and insert the add-on card into its slot on the motherboard.
DDR 2 Slot
Release Tab Release Tab
DDR2
Notch Notch
Release
Note
Release
Note