SuperiorFireplaces.us.com
126871-01B
15
INSTALLATION
Continued
10. Carefully insert fireplace into cabinet
mantel
(see
Figure 13
)
. Be careful not to
scratch or damage hearth base or cabinet
mantel.
11. Place metal trim on shoulder screws lo-
cated on the side and top of the fi replace
(see
Assembling Perimeter Trim
). Firmly
snap trim over shoulder screws. Align
fi replace in mantel assembly so the trim
overlaps mantel evenly on all three sides.
12. Lower bottom louver door. Use 3" wood
screws provided with mantel accessory
to attach fi replace to base (see mantel
instruction sheet).
Assembling Perimeter Trim
Side
Trim
Top Trim
Mitered Edge
Figure 14 - Assembling Perimeter Trim
Shim
Set Screws
Adjusting
Plate
Slot
Slot
1. Remove packaging from three remaining
pieces of trim.
2. Locate two adjusting plates with set
screws, and two shims in the hardware
packet.
3. Align shim under adjusting plate as shown
in
Figure 14
.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim
(see
Figure 14
).
Figure 15 - Removing Upper Louver
Assembly
Upper Louver
Assembly
Black
Screws
Blower Bracket
Mounting Holes
Figure 13 - Installing Fireplace into
Mantel Assembly
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim
(see
Figure 14
).
6. While fi rmly holding edges of trim together,
tighten both set screws on the adjusting
plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set trim assembly aside for later
installation.
INSTALLING BLOWER ACCESSORY
GA3450TA
Removing Upper Louver Assembly
To install the blower accessory, you must fi rst
remove the upper louver assembly.
1. Lift screen off heater.
2. Remove 4 screws from louver assembly
(see
Figure 15
).
Save these screws.
3. Pull louver assembly straight out from the
cabinet. Be careful not to scratch the paint.
Set louver assembly and screws aside.
Removing Valve Cover Shield
1. Open bottom louver assembly by swing-
ing the assembly down
(see
Figure 16,
Page 16
).
2. Using short Phillips screwdriver, remove
the screw under the center of the branch
support. Rotate valve cover shield clock-
wise and slide out.
IMPORTANT
:
Do not remove shoulder
screw on the left side of valve cover shield.
Slide the valve cover shield off of the shoul-
der screw
(see
Figure 16, Page 16
).
All manuals and user guides at all-guides.com
