Chapter 4
Installing a Server Into a Chassis
37
FIGURE 4-5
Tightening the Screws at the Top of a Netra ct 400 Server
5. Using a No. 2 Phillips screwdriver, tighten the black captive screws at the bottom
of the server.
Tighten the screws on the server to a torque of 0.45 - 0.68 N.m (4 - 6 in.-lb).
■
If you are installing a Netra ct 800 server, tighten the three black captive screws at
the bottom of the server (
FIGURE 4-6
).
■
If you are installing a Netra ct 400 server, tighten the two black captive screws at
the bottom of the server (
FIGURE 4-7
).
ALARM
ETHERNET
CompactPCI
TM
COM
STATUS
READY
RESET
ABORT
microsystems
HDD0
ALARM
ETHERNET
CompactPCI
TM
COM
STATUS
READY
RESET
ABORT
microsystems
HDD0
Summary of Contents for Netra ct
