Sun Microsystems Netra 240, Service Manual

Page: 10 / 154

x Netra 240 Server Service Manual • June 2004
FIGURE 3-5
Removing and Installing a Hard Drive 43
FIGURE 3-6
Removing a DVD Drive 46
FIGURE 3-7
Location of the DVD Drive Slot With a Filler Panel 48
FIGURE 3-8
Removing a Power Supply Unit 50
FIGURE 4-1
Removing the Alarm Board 55
FIGURE 4-2
Removing the Front Fan Assembly Tray 57
FIGURE 4-3
Removing the SCSI Interface Board 59
FIGURE 4-4
Lifting the SCSI/IDE Cable Clamp 62
FIGURE 4-5
Removing the SCSI Interface Board Cable and the IDE Cable From the System Board 63
FIGURE 4-6
Removing the System Configuration Card Reader Cluster 64
FIGURE 5-1
Removing/Rotating the Air Duct and Rear Fan Assembly 69
FIGURE 5-2
System Board CPUs and Corresponding Memory Locations 71
FIGURE 5-3
Removing and Inserting Memory 73
FIGURE 5-4
Location of the PCI Lockdown Screw 77
FIGURE 5-5
Location of the PCI Lockdown Bracket 78
FIGURE 5-6
Removing and Installing the Upper Half-Length PCI Cards 79
FIGURE 5-7
Removing and Installing the Lower Full-Length PCI Card 80
FIGURE 5-8
Removing the Power Distribution Board 82
FIGURE 5-9
Disengaging a Power Supply Unit 83
FIGURE 5-10
Removing and Installing the Hardware Cryptographic Module 86
FIGURE 5-11
Removing the PCI Riser Card Assembly 88
FIGURE 5-12
Disconnecting the PDB Wiring Harness From the System Board 89
FIGURE 5-13
Lifting the SCSI/IDE Cable Clamp 90
FIGURE 5-14
Removing the SCSI Interface Board Cable and the IDE Cable From the System Board 91
FIGURE 5-15
Detaching the Front Fan Assembly Cables From the System Board Connectors 92
FIGURE 5-16
Removing the DB-9 and SCSI Jackposts From the Server 93
FIGURE 5-17
Removing and Installing a System Board 94
FIGURE 5-18
Location of the CPU Heat Sink Assemblies 95
FIGURE 5-19
Detaching the Fan Power Cables 96
FIGURE 5-20
Unlocking the Heat Sink Fasteners 97