Sun Microsystems Netra 240, Service Manual

Page: 83 / 154

Chapter 4 Removing and Replacing Rotating Service Module Components 65
Installing the System Configuration Card Reader
Cluster
1. Place the system configuration card reader cluster in position in the rotating
service module (
FIGURE 4-6
).
Ensure that the four tabs are properly inserted into their locations.
2. Using a No. 2 Phillips screwdriver, tighten the two captive screws to secure the
cluster to the rotating service module (
FIGURE 4-6
).
3. Plug the cables back in:
a. Plug the IDE cable into the system board.
b. Plug the bezel cables into the SCSI interface board.
c. Plug the DVD power/I
2
C interface ribbon cable into the SCSI interface board.
d. Plug the SCSI interface cable.
4. Press the SCSI/IDE cable clamp back down to secure the SCSI interface and IDE
cables.
The cable clamp is attached to the chassis and has a green cap. See
FIGURE 4-4
for the
location of this clamp.
5. Close the rotating service module.
See “Closing the Rotating Service Module” on page 31 .
6. Install the server cover.
See “Installing the Server Cover” on page 29 .
7. Grip the bezel at the two finger holds and rotate it down to its open position
(
FIGURE 2-4
).
8. Install the DVD drive back into the server.
See “Installing a DVD Drive” on page 47 .
9. Install the system configuration card back into the system configuration card
reader.
See “Inserting a System Configuration Card” on page 39 .
10. Close the bezel door.
11. Power on the server.
See “Powering On the Server” on page 20 .