Sun Microsystems Netra 240, Service Manual

Page: 57 / 154

Chapter 3 Removing and Replacing Front and Rear Panel Components 39
3. Cut and remove the tie wrap that secures the system configuration card, and
remove the card from the system configuration card reader (
FIGURE 3-4
).
Note –
Once the system configuration card is inserted into the system configuration
card reader, secure a new tie wrap to discourage accidental or unintentional removal
of the card.
FIGURE 3-4
Removing and Inserting a System Configuration Card
Inserting a System Configuration Card
1. Insert the system configuration card into the system configuration card reader
(
FIGURE 3-4
).
2. Replace the tie wrap on the card.
System configuration card
System configuration card reader
Tie wrap