Sun Microsystems Netra 240, Service Manual

Page: 77 / 154

Chapter 4 Removing and Replacing Rotating Service Module Components 59
6. Open the rotating service module.
See “Opening the Rotating Service Module” on page 30 .
7. Ensure that the server is properly grounded.
See “Avoiding Electrostatic Discharge” on page 32 .
8. Using a No. 2 Phillips screwdriver, loosen the green captive screw on the top of
the SCSI interface board (
FIGURE 4-3
).
FIGURE 4-3
Removing the SCSI Interface Board
9. Detach the bezel cables, the SCSI interface cable, the DVD power/I
2
C interface
ribbon cable, the alarm board cable, and the SCSI interface board power cable
from the SCSI interface board (
FIGURE 4-3
).
10. When standing in the front of the server, slide the SCSI interface board to the left
and then up to remove it from the rotating service module.
Captive screw
SCSI interface board
SCSI interface board
removal direction