Sun Microsystems Netra 240, Service Manual

Page: 95 / 154

Chapter 5 Removing and Replacing Miscellaneous Internal Components 77
Removing a PCI Card
1. Power off the server.
See “Powering Off the Server” on page 22 .
2. Remove the server cover.
See “Removing the Server Cover” on page 27 .
3. Open the rotating service module.
See “Opening the Rotating Service Module” on page 30 .
4. Ensure that the server is properly grounded.
See “Avoiding Electrostatic Discharge” on page 32 .
5. Completely remove the air duct and rear fan assembly.
See “Removing or Rotating the Air Duct and Rear Fan Assembly” on page 68 .
6. Using a No. 2 Phillips screwdriver, unscrew the PCI lockdown screw on the back
of the server (
FIGURE 5-4
).
FIGURE 5-4
Location of the PCI Lockdown Screw
PCI lockdown
screw