Sun Microsystems Netra 240, Service Manual

Page: 75 / 154

Chapter 4 Removing and Replacing Rotating Service Module Components 57
FIGURE 4-2
Removing the Front Fan Assembly Tray
6. Using a No. 2 Phillips screwdriver, loosen the green captive screw that secures the
front fan assembly tray to the rotating service module (
FIGURE 4-2
).
7. Lift the front fan assembly tray straight up and remove it from the server
(
FIGURE 4-2
).
Installing the Front Fan Assembly Tray
1. Place the front fan assembly tray into position in the rotating service module
(
FIGURE 4-2
).
2. Tighten the captive screw to secure the front fan assembly tray to the rotating
service module (
FIGURE 4-2
).
Front fan assembly tray
Captive screw
System board connectors
Routing post