Sun Microsystems Netra 1290, Administration Manual

Page: 50 / 146

32 Netra 1290 Server System Administration Guide • May 2006
LOM Command Syntax
TABLE 3-1
summarizes the options and arguments of the
lom
command.
Monitoring the System From the Solaris
OS
There are two ways of interrogating the LOM device (SC) or of sending it commands
to perform:
■
By executing LOM commands from the
lom>
shell prompt.
■
By executing LOM-specific Solaris commands as superuser as described in this
chapter.
The Solaris commands described in this section are run from the
/usr/sbin/lom
utility.
TABLE 3-1
lom
Command Options and Arguments
lom
Option Description
-A on|off number Turns alarm number on or off. number is either 1 or 2
-a
Displays all component status data.
-c
Displays LOM configuration.
-E on|off
Switches event logging to the console
on
or
off
.
-e
number
,
level Displays the event log for number of lines of event level . level is 1, 2, or 3.
-f
Displays fan status. This information is also displayed in the output from the
Solaris
prtdiag -v
command.
-G
firmwarefilename
Upgrades the firmware with firmwarefilename .
-l Displays the status of the Fault and Alarms LEDs.
-t Displays temperature information. This information is also displayed in the
output from the Solaris
prtdiag -v
command.
-v Displays the status of the voltage sensors. This information is also displayed in
the output from the Solaris
prtdiag -v
command.
-X
xy Changes the escape sequence to xy .