Sun Microsystems Cobalt LX50, User Manual

Page: 89 / 138

Customer Replaceable Unit (CRU) Procedures
User Guide—Sun Cobalt LX50 Server 5-5
Floppy/CD-ROM Combo Module
To replace the Floppy/CD-ROM module, follow these steps:
1. Before removing the cover to work inside the system, observe the safety guidelines previously stated.
2. Remove the bezel from the front of the chassis.
3. As shown in Figure 64, rotate the module’s handle bar up (A) and pull on the handlebar to remove the module
from the flex bay.
Figure 64. Floppy/CD-ROM Module Replacement
4. Slide a new module into the flex bay until you feel the connectors touch.
5. Push the module in (using the handlebar) about 3/16 of an inch (5mm) more to fully engage the connectors.
6. Rotate the handle bar down.
7. Reinstall the bezel.
!
Caution: A CD-ROM drive/FDD module is NOT hot swappable. Before replacing it, you must
first take the server out of service, turn off all peripheral devices connected to the system, turn
off the system by pressing the power button, and unplug the AC power cord from the system or
wall outlet.
✍
Note: The floppy/CD-ROM module may be replaced with a hard disk drive. If you do this, you
need to install a small plastic cover to cover the gap at the right side of the drive that is left by
removal of the (larger size) floppy/CD-ROM module. The plastic cover is included in the
accessory kit.
✍
Note: The Comprehensive Test should be run after changing any FRU, CRU, or adding an
optional component. See “Run System Diagnostic Test” on page 4-15.
OM11662
A