©2017 Extractor Corporation
115-V 20-Amp 60-Hz SUITMATE
®
Unit
19
REMOVE LID FROM BLACK PLASTIC TOP
'
o
7K
i
V
),567
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Parts used in this process: (2) AEC1410 S.S.
Pop Rivets, (2) AEC1416 Black O-Rings, (1) AEC1704 S.S. Lock Washer, (1) BEC1403 Hinge Pin, Left,
(1) AEC1405 Actuator Screw, (1) AEC1404 S. S. Actuator Sleeve, (1) BEC1404 Hinge Pin, Right, and
(1) AEC 1803 Acorn Nut. Plus any components required to reinstall the Sub Top and Top Assemblies
(Page 17).
REMOVE LID
1) Remove SUITMATE
®
unit from the Wall Mount Bracket. See instructions beginning on Page 14.
2) Remove Top and Sub-Top Assemblies. See instructions beginning on Page 15.
3) Place the Top Assembly upside down.
4) Remove the Acorn Nut, Lock Washer, and Actuator Sleeve from the Actuator Screw.
5) Unscrew the Actuator Screw from the Left Hinge Pin.
6) Remove the (2) rivets from the outer edge of the S.S. Lid that hold the Left Hinge Pin.
a. Punch out the center of each rivet with a small drift pin.
b. Drill out each rivet.
c. Chisel off the rivet heads. Make certain the rivets are completely removed.
7) Remove the hinge pin through the metal Lid. Set the Left Hinge Pin aside for reassembly later.
8) Remove the Lid from the Top Assembly.
Note:
A rubber O-ring is located on each hinge between the metal
/
id and the plastic Top.
REPLACE LID
1) Insert the Right Hinge Pin into the Top and then insert the Left Hinge Pin through the Lid and into the Top.
Note:
0
ake certain that you have reinstalled the Rubber O-Ring on both hinge pins.
2) Rivet the Left Hinge Pin to the Lid.
Note:
%
e certain the
+
inge Pin is
À
ush against the inside of the
/
id prior to riveting.
3) Screw in the new Actuator Screw, re-install Actuator Sleeve, and fasten with Lock Washer and Acorn Nut.
(See illustration below)
Note:
0
ake certain that with the lid open, the Actuator Screw does not touch the inside of the
%
lack
Plastic Top.
4) Reinstall the Sub-Top and Top assemblies. See instructions beginning on Page 17.
5) Reattach the SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 14.
6) Retest the SUITMATE
®
unit for proper operation, refer to TESTING AND OPERATION on page 7.
ACORN NUT (1) AEC1803
HINGE PIN, LEFT (1) BEC1403
(1) AEC1405
S.S. ACTUATOR SCREW
(1) AEC1704
S.S. LOCKWASHER
(1) AEC1404
S.S. ACTUATOR SCREW SLEEVE
Summary of Contents for Swimsuit Water Extractor 115V
Page 1: ...115V 60Hz Manual Installation Maintenance...
Page 2: ......
Page 57: ......
Page 58: ...v052017...
