Suitmate Swimsuit Water Extractor 115V, Installation & Maintenance

Page: 12 / 58

©2017 Extractor Corporation 115-V 20-Amp 60-Hz SUITMATE ® Unit
10
e. Repeat step D using clean water until a free À ow of water is established and the discharge water
is clear of debris.
f. If you cannot establish a free À ow of water or the discharge water is spilling out from under the unit,
the tailpiece is plugged or the drain channels are blocked. Locate the blockage by referring back to
step A under Inspection. After removing the blockage, repeat steps C through E.
g. Reinstall the drain hose or P-trap.
MONTHLY
1) Case and Top care
a. Wipe down the Black Plastic Top with Armor All
®
or its equivalent.
b. Clean and polish the stainless steel Case with a stainless steel cleaner. If À ash rust or stains are
present, use a Scotch Brite
®
pad or medium grade steel wool to remove them. Take care to rub
stains out by going with the grain of the case (up and down – not sideways). Follow stain removal by
polishing the Case a stainless steel cleaner.
2) Testing the GFCI
a. Locate the weatherproof junction box in the bottom rear of the unit. Flip open the cover of the
junction box to expose the ³ TEST” and ³ RESET” buttons on the face of the GFCI.
b. Test the GFCI by depressing the ³ TEST” button the ³ RESET” button should pop out. Depress the
³ RESET” button to resume normal functioning. If the ³ RESET” button does not pop out during testing
or is unable to be depressed back into place, the GFCI may be faulty; please contact Extractor
Corporation at 800-553-3353 for further assistance.
If the unit does not operate, please refer to the TROUBLESHOOTING GUIDE. If you have any questions or
problems, please contact Extractor Corporation at 800-553-3353.