©2017 Extractor Corporation
115-V 20-Amp 60-Hz SUITMATE
®
Unit
15
SUB-TOP ASSEMBLY
CASE ASSEMBLY
EC12
EC 6
(6) AEC 1205
WITH LID (1) EC 4
TOP ASSEMBLY
(2) AEC 1605
BLACK ALUMINUM
BLACK BRAKE TIP
POP RIVET
REMOVE THE TOP AND SUB-TOP ASSEMBLIES
'
o
7K
i
V
),567
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Parts used in this process: (6) AEC1205 Black
Aluminum Pop Rivets, (2) AEC1605 Black Rubber Brake Tips, and (3) AEC1240 Aluminum Pop Rivets.
REMOVE TOP ASSEMBLY
1) Remove the SUITMATE
®
unit from the Wall Mount Bracket following the instructions beginning on Page 14.
2) Place the SUITMATE
®
unit in an upright position.
3) Lift the Lid. Remove the Black Rubber Brake Tips from the (2) Brake Rods. If damaged, they must
be replaced.
4) Remove the (6) rivets from around the outer edge of the Black Plastic Top.
a. Punch out the center of each rivet with a small drift punch.
b. Drill out each rivet.
Note:
0
ake certain the drill bit does not reach a depth of more than
ò
-inch to avoid damaging the
%
lack
3
lastic
/
iner.
c. Gently chisel off the rivet heads. Make certain the rivets are completely removed.
5) Separate the Black Plastic Top from the unit. Remove the Top by grasping the sides and lifting straight up
while the Lid is in the upright position.
6) Be careful not to bump the Riser Cable Assembly on the Sub-Top. Set the Top Assembly aside
for reassembly.
Summary of Contents for Swimsuit Water Extractor 115V
Page 1: ...115V 60Hz Manual Installation Maintenance...
Page 2: ......
Page 57: ......
Page 58: ...v052017...
