Suitmate Swimsuit Water Extractor 115V, Installation & Maintenance

Page: 19 / 58

©2017 Extractor Corporation 115-V 20-Amp 60-Hz SUITMATE ® Unit
17
REMOVE SUB-TOP ASSEMBLY
1) Remove the Nut from the Turnbuckle that is attached to the Riser Cable. Set the Nut aside for reassembly.
2) Pull the Riser Cable with Turnbuckle down through the hole in the Riser Shuttle.
3) Remove the (2) rivets from around the outer edge of the Sub-Top and the (1) rivet from the top.
a. Punch out the center of each rivet with a small drift punch.
b. Drill out each rivet.
Note: 0 ake certain the drill bit does not reach a depth of more than ò -inch to avoid damaging the
% lack 3 lastic / iner.
c. Chisel off the rivet heads. Make certain the rivets are completely removed.
4) Separate the Sub-Top from the SUITMATE
®
unit. Remove the Sub-Top by grasping the sides and lifting
straight up.
5) Remove rivet debris and any other foreign objects from the Liner.
REPLACE SUB-TOP ASSEMBLY
1) Place the SUITMATE
®
unit in an upright position.
2) Locate the (2) Brake Rod holes in the Sub-Top gasket and align them with the Brake Rods.
3) Push the Sub-Top down over the Brake Rods.
4) Push the Riser Cable Turnbuckle up and through the hole in the Riser Shuttle.
5) Reattach the Nut (removed in step 1 above) to the Turnbuckle that is attached to the Riser Cable.
6) Align the (3) holes in the Sub-Top (one on each side and one on the top) with the respective holes
in the Case.
Note: 0 ake sure that the lip of the Sub-Top is on the outside of the Case.
7) Fasten the Sub-Top to the case with (3) Aluminum Pop Rivets.
REPLACE TOP ASSEMBLY
1) Place the SUITMATE
®
unit in an upright position.
2) Lift the Lid on the Top Assembly and locate the (2) Brake Rod holes in the Top and align them with the
Brake Rods. Push the Top down over the Brake Rods.
3) Align the (6) holes in the outer edge of the Top with the corresponding (6) holes in the Case.
4) Fasten the Top to the Case with (6) Black Aluminum Pop Rivets.
5) Replace the (2) Black Rubber Brake Tips.
Note: Check the 0 icro Switch alignment by following the 0 ICRO S : ITC + A '- UST 0 ENT 3 ROCE ' URE
section (Page 47) in this manual.
6) Reattach the SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 14.
7) Retest the SUITMATE
®
unit for proper operation, refer to TESTING AND OPERATION on page 7.