Torq-Tronics 2
®
/
Owners Manual / Appendix A: Serial Commands
Appendix A:
Serial Commands
Most of the Serial Commands are Alpha based. However, we do have some numeric commands
that contain a 0 (ZERO) not the letter O.
An example of a Serial Command containing a numeric character would be D0 (ZERO).
Table of Contents
A.1 Default Factory Communication Settings ...............................................................28
A.2 Clearing ‘Overload’ of Torq-Tronics 2 process .......................................................28
A.3 To See the Captured Overload Point of Torq-Tronics 2 process ...........................28
A.4 Request tester to generate and print a report of data captured ..............................29
A.5 Serial Messaging Command List ............................................................................29
A.5.1
Special ASCII commands: ...................................................................................29
A.5.1.5 Enter Calibration Mode .......................................................................................29
A.5.1.6 Exit calibration mode and unlock the keypad ..................................................29
A.5.1.7 Toggles the Enter/exit state of Diagnostic mode ...........................................29
A.5.1.8 Enter Diagnostic mode ........................................................................................29
A.5.1.9 Exit Diagnostic mode ...........................................................................................29
A.5.2
Commands available only when Calibration mode is on: ...............................30
A.5.3
Commands available only when Diagnostic mode is on:................................30
A.6 Commands available at all times .............................................................................31
A.6.1.3 Setup how and what the Torque Print string shall print out. .........................31
A.6.1.4 Retrieve U.S. time date clock ...............................................................................32
A.6.1.5 Set U.S. time date clock type ................................................................................32
A.6.1.6 Retrieve European time date clock .....................................................................32
A.6.1.7 Set European time date clock type .....................................................................32
A. 6.1.8 Clear currently stored records data ....................................................................32
A.6.1.17 Show the auto clear time in seconds ..................................................................33
A.6.1.18 Set the auto clear time in seconds ......................................................................33
A.6.1.22 Print the current torque reading .........................................................................33
A.6.1.23 Show the current number of records stored in memory ................................34
A.6.1.24 Retrieve record number and print per the last state of the TX command ..34
A.6.1.26 Turn the memory of the tester ‘ON’ .................................................................34
A.6.1.27 Turn the memory of the tester ‘OFF’ ...............................................................34
A.6.2
Special TTM 2 interface commands: .................................................................35
Owners Manual
Torq-Tronics 2
Sturtevant Richmont
Direct: 1 847/455-8677
Toll-Free: 800/877-1347
www.srtorque.com
11
/16/201
7
REV
E
. Document Page 27 of 39
