Stryker Crossfire 2, Manual, Page: 29 / 762

EN-25
Troubleshooting
Problem Solution
Console
A hardware fault
is detected • Turn the power off and on again.
• If the problem persists, contact a Stryker
representative or return the console for repair.
The AC voltage is
incorrect • Turn the power off and on again.
• If the problem persists, contact a Stryker
representative or return the console for repair.
A software fault
is detected • Turn the power off and on again.
• If the problem persists, contact a Stryker
representative or return the console for repair.
The system does
not power on • Check the power cord to ensure it is properly
connected.
• Check to ensure the cord is connected to a
grounded outlet.
The electrical
interference is
sporadic • Power down all electrical equipment not in use.
• Increase distance of other electrical equipment.
• Connect the unit and other equipment into different
outlets.
The generator
temperature is
too high • Ensure that there is proper airflow around the unit.
A power-on self
test error has
occurred • Turn the power off and on again.
• If the problem persists, contact a Stryker
representative or return the console for repair.
Handpiece
The temperature
is higher than
normal • Allow the unit to cool before restarting.
The unit has
reached its
recommended
service interval • Contact your Stryker representative.
Disposable
Attachments RF probe is not
ready • Check the connection to the console.
RF probe is
expired • Replace probe.
RF probe
identification is
invalid • Replace probe.
RF probe
communication
error • Check the connection to the console.
• If necessary, replace probe.