Stryker 0702-002-620, Service And Installation Manual

Page: 111 / 232

5. Push
actuator cover
(P/N 0702-014-012) (L) inside chassis enough to remove
actuator cover back
(P/N 0702-014-014) (R). Continue to push
actuator cover
(P/N
0702-014-012) (L) back to remove.
6. Unplug the connector from
docker power coupler assembly
(P/N 0702-014-114) at J1
of the
docker power coupler PCBA
(P/N 0702-014-510) (H).
Carefully
cut all wire ties
used to secure this cable.
7. Unplug the connector from
stepper motor assembly
(P/N 0702-014-123) at the point
where it connects to the
docker main wire harness
(P/N 0702-014-021).
8. Disconnect three connectors from
hall sensor wire harness
(P/N 0702-014-021F).
Each connector is different to prevent from reinstalling incorrectly.
9. Using an adjustable wrench, disconnect
coupling offload hose
(P/N 0702-014-129)
(D) at the connection to the
offload pump
(P/N 0702-014-201). Next, remove the
coupling inlet hose
(P/N 0702-014-128) (C) at the connection to the
water inlet
assembly
(P/N 0702-014-400) (AF)
4-4