Struers Discotom-50, Instruction Manual

Page: 9 / 156

Discotom-50
Instruction Manual
Connect the Recirculation Cooling Unit (optional), product code
TRECA as follows:
Connecting the Recirculation
Cooling Unit (optional)
„
To connect the electric cable for the recirculation pump, remove
the upper back plate on Discotom-50 and follow the
instructions on the wiring diagram found on the inside of the
back plate.
„
Check that when the power is turned on, the pump rotates in
the direction indicated by an arrow on the top of the pump. If
not, switch two of the phases to the pump motor and re-check.
„
Replace the back plate.
„
Clamp the inlet hose to the pump and attach the other end to
the water inlet on Discotom-50
i
.
„
Attach the connector pipe to the water outlet
k
, mount the
large outlet hose and secure with the large hose clamp.
„
Place the tank on the trolley.
„
Place a disposable plastic insert (EXOSP) in the tank and fold
it over the rim.
„
Fill the tank with 63 l water and 2 l Struers Additive. The
water level should be 8-10 cm below the upper rim of the tank.
„
Fit the tank lid and sieve.
„
Roll the trolley into its proper position and place the outlet and
overflow drain hoses
k
&
h
inside the cooling water tank.
Adjust the hose lengths if necessary.
IMPORTANT
c
Too high a level of coolant in the tank might damage the pump. To avoid
this, place the disposable insert so that the pre-punched hole is in front of
the overflow aperture in the tank.
d
Always maintain the correct concentration of Struers Additive in the
cooling water (percentage stated on the Additive container).
Remember to top up with Struers Additive each time you refill with water.
If the recirculation pump is overloaded or blocked, a thermal cut-
out will switch the pump off. This safety cut-out must be reset by
pushing the red button on the back of the Discotom-50
d
before
the machine can be restarted.
Re-set button
5