TRUCK COMPUTER ATC 09
39
Placement
A. Selected level.
B. The selected level's height (as
standard 10 cm higher than when
withdrawal is selected)
C. The actual height of the forks.
Withdrawal
A. Selected level.
B. The height of the selected
level.
C. The actual height of the forks.
Operation
1)
To select withdrawal, press
or for depositing press "I".
2)
The display reads “Select level”. Press the number for the
required level.
Select level:
1
3)
Operate the lifting control until the forks stop. The display
shows the current lift height. Now let the control return to
the neutral position. The forks first go past the selected
level and are then lowered to the correct level.
Interrupting the lift and then continuing is possible without
losing the selection.
001:0261 (0202)
1
4)
When the control is in the neutral position and the level is
reached the display shows “Level reached!!”.
001:0261 (0260)
Level reached!!
Error messages
•
Bad level!!
100% 305h
If the forks are above the selected level (or a level that has
not been preset) the error message “Incorrect level!” is
shown and the selection is not approved.
•
Sys. not zeroed!
100% 305h
If the forks have not activated the resetting sensor after
logging on, the display shows “Syst. not reset” and the
height preset cannot be activated. Lower the forks to the
floor.
Cancel
1)
To cancel/reset a selection, move the lifting lever to
lowering for a moment. The display shows “Level
CANCELLED”.
Instruction Handbook UFW — D008453, B, GBR, ForTranslation
