14 SERVICING AND MAINTENANCE
62
code is shown on the diver's display, this must be reported to
your service organisation.
Truck condition Possible cause
Procedure
The truck does
not start
The battery plug has not
been inserted
Insert the battery plug
The emergency stop
button has been
pressed
Pull up the button for the
emergency stop
The battery capacity is
too low
Charge the battery
Fuse defective
Change the defective
fuse
The key switch is set to
"0" or the truck is not
logged on
Turn the key switch to
position "I" or enter the
appropriate Operator ID
and password
The truck cannot
be driven
The truck is not ready
for use
Carry out all the actions
under the heading "The
truck will not start"
The left foot switch has
not been pressed in
Press in the left foot
switch
Drive fuse defective
Change the defective
drive fuse
Truck condition Possible cause
Procedure
The truck will not
lift the load
The truck is not ready
for use
Carry out all the actions
under the heading "The
truck will not start"
The hydraulic oil level is
too low
Check the level and top
up the hydraulic oil
The battery capacity is
below 20%
Charge the battery
Pump fuse defective
Change the defective
pump fuse
The load is too heavy
Reduce the load Refer
to the maximum
permitted weight on the
load limit plate
The driving seat switch
is not activated
Sit in the driving seat
while operating the
levers
Dismantling and assembling the panels
Dismantling and assembling the motor cover
1)
Adjust the seat so that it is locked in its rearmost position.
If the footplate is adjustable, it should be in its central
position.
2)
Remove the motor cover (A) by grasping it and carefully
easing it upwards.
3)
Refit in the reverse order.
Instruction Handbook UFW — D008453, B, GBR, ForTranslation
