STG global TANVAC HDV3000, Operator'S Manual

Page: 98 / 329

1. Stop the engine and allow the engine to cool.
Loosen the cooling system filler cap slowly in
order to relieve any pressure. Remove the cooling
system filler cap.
2. Open the cooling system drain valve (if equipped).
If the cooling system is not equipped with a drain
valve, remove the cooling system drain plugs.
Allow the coolant to drain.
NOTICE
Dispose of used engine coolant properly or recycle.
Various methods have been proposed to reclaim
used coolant for reuse in engine cooling systems.
The full distillation procedure is the only method ac-
ceptable by Caterpillar to reclaim the used coolant.
For information regarding the disposal and the
recycling of used coolant, consult your Caterpillar
dealer or consult Dealer Service Tools.
Flush
1. Flush the cooling system with clean water in order
to remove any debris.
2. Close the drain valve (if equipped). Clean the drain
plugs. Install the drain plugs. Refer to Torque
Specifications, SENR3130 for more information on
the correct torques.
NOTICE
Do not fill the cooling system faster than 5 L
(1.3 US gal) per minute to avoid air locks.
Cooling system air locks may result in engine
damage.
3. Fill the cooling system with clean water. Install the
cooling system filler cap.
4. Start and run the engine at low idle until the
temperature reaches 49 to 66 °C (120 to 150 °F).
5. Stop the engine and allow the engine to cool.
Loosen the cooling system filler cap slowly in
order to relieve any pressure. Remove the cooling
system filler cap. Open the drain valve (if
equipped) or remove the cooling system drain
plugs. Allow the water to drain. Flush the cooling
system with clean water. Close the drain valve (if
equipped). Clean the drain plugs. Install the drain
plugs. Refer to Torque Specifications, SENR3130
for more information on the correct torques.
Fill
NOTICE
Do not fill the cooling system faster than 5 L
(1.3 US gal) per minute to avoid air locks.
Cooling system air locks may result in engine
damage.
1. Fill the cooling system with Extended Life Coolant
(ELC). Refer to this Operation and Maintenance
Manual, “Refill Capacities and Recommendations”
topic (Maintenance Section) for more information
on cooling system specifications. Do not install the
cooling system filler cap.
2. Start and run the engine at low idle. Increase the
engine rpm to high idle. Run the engine at high
idle for one minute in order to purge the air from
the cavities of the engine block. Stop the engine.
3.
Check the coolant level. Maintain the coolant level
within 13 mm (0.5 inch) below the bottom of the
pipe for filling. Maintain the coolant level within
13 mm (0.5 inch) to the proper level on the sight
glass (if equipped).
4. Clean the cooling system filler cap. Inspect the
gasket that is on the cooling system filler cap. If
the gasket that is on the cooling system filler cap is
damaged, discard the old cooling system filler cap
and install a new cooling system filler cap. If the
gasket that is on the cooling system filler cap is not
damaged, use a
9S-8140
Pressurizing Pump in
order to pressure test the cooling system filler cap.
The correct pressure for the cooling system filler
cap is stamped on the face of the cooling system
filler cap. If the cooling system filler cap does not
retain the correct pressure, install a new cooling
system filler cap.
SEBU8312-03 61
Maintenance Section
Cooling System Coolant (ELC) - Change