Z001019/0_7_January 2011
Page GENERAL-29
GENERAL
SERVICE MANUAL MARINE ENGINES
ToC
12.
Remove the air filter, plug the exhaust elbow and
remove the inlet pipe to the tandem/triple cooler,
see photo. See ill.3 and ill.4
13.
Fill a spray bottle with the preservation oil Shell Ensis
Engine Oil 30 (art.nr. Z050323-0, 5liter canister, ade-
quate quantity incl. in all Preservation Service Kits).
14.Whilst cranking the engine over, by turning the
start key, spray the preservation oil into the turbo inlet.
See ill.5
15.
Continue this process for 20 to 30 seconds.
16.
Refit the fuel feed line to the engine, ensure fuel supply
over canister Z010014-0 (preservation fuel) and turn the
ignition on, the fuel pump runs for 10 sec automatically
refilling the fuel system. Repeat until fuel comes from the return line.
NOTE:
For corrosion protection of fuel system leave system filled with preservation fuel Z010014-0 till
next preservation or engine is put into operation
17.
*Only by 2
nd
Preservation:
After two years engine storage replace engine coolant water (art. nr. Z011785-0, 5 liter canister, adequate
quantity incl. in 2
nd
Preservation Service Kit) and fill between min/max-level in coolant expansion tank.
18.
Replace all pipes and connections to original condition and restore engine.
19.
Record carried out Storage Preservation Procedure in following documents:
1) STEYR MOTORS WARRANTY REGISTRATION CARD
(to find under: Operation, Maintenance and Warranty Manual Z001022/ chapter WARRANTY)
2) COMMISSIONING REPORT
(to find under: Installation Manual Z001007/0 / chapter 19. APPENDIX)
Ensure notification in above documents for approval of extended STEYR MOTORS BASE ENGINE
WARRANTY.
Otherwise BASE ENGINE WARRANTY will end for PLEASURE /COMMERCIAL duty after 1 year
starting from STEYR MOTORS manufacturing date.
NOTE:
For manufacturing date see sticker on engine plastic cover!
20.
Note the date of preservation on:
1) sticker for engine (sticker incl. in corresponding Preservation Service Kit)
2) sticker for Maintenance Log of Operation, Maintenance and Warranty Manual Z001022-0
(sticker incl. in corresponding Preservation Service Kit)
This preservation procedure must be done every year and ensures that all of the air ways systems, raw
water systems, oil system and the cylinders are protected against corrosion.
This procedure is repeatable up to a maximum of three times, giving a shelf life of up to three
years (36 months).
After 3 years stocking, starting from STEYR MOTORS manufacturing date, engine must be put
into operation for BASE ENGINE WARRANTY approval.
However preservation procedure can be continued every year after 3 years stocking without
BASE ENGINE WARRANTY approval from STEYR MOTORS.
NOTE:
When commissioning or running an engine that has been preserved as stated above the engine will run
roughly and smoke for the first few minutes. Do not be alarmed as this is normal until
the deposits of the preservation materials have cleared.
ill. 5
