Page FUEL SYSTEM - 28
Z001019/0_6_July 2008
03 FUEL SYSTEM
SERVICE MANUAL MARINE ENGINES
03.08.02
Install control solenoid
To install control solenoid assembly onto camshaft
housing, proceed as follows:
NOTE:
Use new gasket for control solenoid if fitted.
O-ring can be re-used.
1
Remove camshaft housing cover.
2
Move control rack by hand (ill.1) to front position and
hold.
3
Insert control rack lever in to the solenoid as shown.
(ill.2/pos.1)
4
Bring up control solenoid assembly parallel to sealing
surface of camshaft housing, put it onto the dowel
pin(s) (ill.3/pos.1) and hold.
5
Slowly release control rack and fasten control so-
lenoid housing by means of 4 screws.
6
For 4 cyl. engines only
Secure the 4 screws with LOCTITE 243 and tighten
with a torque of
23 Nm +/-2
.
For 6 cyl. engines only (item 8-9)
7
Cover the two lower screws with LOCTITE 243 and
slightly tighen.
8
Cover the two upper screws with LOCTITE 243.
Bring into position bracket with potentiometer
accelerator and fix with upper screws. Tighten the 4
screws with a torque of
23 Nm+/-2
.
9
Check whether the control rack can be moved over a
distance of
approx. 18 mm
.
ATTENTION:
Pin of control rack position sensor is
spring-loaded and might easily slip off
from the face of control rack lever,
during assembly. In such a case, the
control rack is blocked and thus
prevents resetting to zero delivery
===> ENGINE FAILURE.
10
Remaining assembly is done in reverse order.
NOTE:
The rack position sensor is magnetism
sensitive. All external magnets must
be kept away as the may disturb the
sensor.
08.02 ill.1
08.02 ill.3
08.02 ill.2
1
1
2
ToC
