Steris HarmonyAIR G Series, Operator'S Manual

Page: 25 / 60

3-1
Operating Instructions Operator Manual 10043124
3.1 Intensity Controls The wall-mounted HarmonyAIR™ Surgical Lighting System G Series
wall control allows the user to adjust the lighthead intensity level by
pressing membrane switches (or
buttons ). Each lighthead is
capable of seven light intensity levels, 1 being the lowest intensity
and 7 being the highest. An identifying number on the control display
corresponds to the same number on the lighthead suspension arm.
Additionally, each lighthead has its own
onboard intensity control
located above the lighthandle adjacent to the lens. These controls
are usually referred to as the surgeon's control buttons or as the
surgeon's control (see
Figure 3-2 ).
3.1.1 Activate the HarmonyAIR
Surgical Lighting System G
Series
Refer to Figure 3-1 . Press ON/OFF touch pad. This turns the system
on in active mode and restores system lightheads to same intensity
levels as before system was turned OFF.
When the system is ON, ON/OFF LED glows green and it does not
blink (i.e., is steady). This state is referred to as ACTIVE mode. When
the system ON/OFF switch is pressed while system is ACTIVE,
system switches to STANDBY mode. In STANDBY mode all lights
turn off, the optional camera module (if present) turns off, and ON/
OFF LED glows green and
blinks.
• Intensity levels for one to three lightheads can be controlled
remotely from one wall control.
Figure 3-1. Wall Control (with Optional Camera Controls)
Lighthead
Intensity
Controls
Battery
Backup
Indicator
Camera
Controls
Camera
Status
Indicator
System
ON/OFF
Touch Pad
Camera
ON/OFF
Touch Pad
System
Fault
Indicator
WARNING – ELECTRIC
SHOCK HAZARD: The OFF
position on the system ON/
OFF touch pad of the wall
control turns off control to
camera and lightheads, but
system is still energized. This
mode is referred to as
STANDBY, and the ON/OFF
LED flashes once per second
while system is in this mode.
!
OPERATING INSTRUCTIONS
3