Steris HarmonyAIR G Series, Operator'S Manual

Page: 19 / 60

2-1
Installation Verification Operator Manual 10043124
Equipment Drawings showing all of the space and utility
requirements were sent to the purchaser after the order for this
surgical light was received. The clearance space shown on the
drawing is necessary for proper installation, operation and
maintenance of this fixture.
Installation and Uncrating Instructions were furnished with the
Lighting Fixture.
If any of these documents are missing or misplaced, contact
STERIS, giving the serial and model numbers of the equipment.
Replacement copies will be sent to you promptly.
2.1 Pre-operation
Checklist
Before operating the equipment, complete the pre-operation
checklist. It is essential to the safe operation and continuing
maintenance of this equipment to verify that the installation is
complete and correct.
2.1.1 Check Suspension
Movement
Check all suspension joints for compromised integrity, such as loose
fasteners or components.
❑
Verify that suspension system moves through all articulations
smoothly without binding. Lightheads and monitors should move
smoothly and easily. When positioned, the lighthead support
arms (or monitor support arms) should not drift. If binding or
drifting is present in suspension movements, call your STERIS
service representative to make adjustments.
2.1.2 Check System Operation Verify that electrical power to the control center is on.
.
❑
When wall control ON/OFF switch is OFF, wall control ON/OFF
LED flashes. Turn control ON by pressing wall control ON/OFF
touch pad. Verify that wall control touch pads function. Check
intensity levels for each system lighthead. If optional camera
module is installed, check camera controls.
NOTE: Turn power OFF to each lighthead using intensity
controls, and to optional camera (if installed) when testing is
complete.
❑
Check Module Failure Indicators: If LED Module(s) Requires
Service graphic on wall control display is lit, one or more
modules may require service.
❑
Check Module Failure LED: If the LED on any of the lightheads
is blinking, one or more LED modules may require service.
Check lighthead status LED.
❑
Check Intensity Controls at Each Surgeon's Control: Verify
that the intensity level can be increased and decreased at each
lighthead using the surgeon's control buttons.
WARNING – ELECTRIC SHOCK
HAZARD: Do not remove covers
or perform service other than as
described in this operator
manual. Refer servicing to
qualified service personnel.
!
WARNING – PINCHING HAZARD:
Pinch points are created during
extreme articulation of the
suspension system. Do not place
hands on or near the suspension
knuckle during lighthead
articulations.
!
WARNING – ELECTRIC SHOCK
HAZARD: The OFF position on
the system ON/OFF touch pad of
the wall control turns OFF control
to camera and lightheads, but
system remains energized. This
mode is referred to as STANDBY,
and the ON/OFF LED flashes once
per second while system is in this
mode.
!
Module(s) Requires Service
Indicator
INSTALLATION VERIFICATION AND
TECHNICAL SPECIFICATIONS
2