Torch Runner (HS)
Torch Runner (HS) Operator’s Manual
21
5.8. Circle cutting attachments
5.8.1. Circle cutting attachment for 240
–1000 mm radius
Allows cutting holes with the radius of 240
–1000 mm (0.8–3.3 ft; when used with the
standard rack). To install, use the 3 mm hex wrench and unscrew two front screws
from the bottom plate, and then use them to tighten the bracket to the exposed holes.
Next, use the 4 mm hex wrench to fix the arm to the side wall with two M5x16
screws. Set the pilot pin above the center of the circle and turn on the magnet with
the magnet lever.
Part number:
CYR-0475-22-00-00-0
Pilot pin
Magnet lever
Bracket
