Torch Runner (HS)
Torch Runner (HS) Operator’s Manual
11
3.3. Changing the unit of speed
To change the unit of speed between centimeters per minute and inches per minute,
unplug the carriage from the power source and follow the steps shown in Fig. 2.
After the unit is changed and the carriage powered, the current unit of measure
appears. When the jumper cap connects the left and center pin, the display shows
and the speed is given in centimeters per minute. When the jumper cap connects
the center and right pin, the display shows
and the speed is given in inches per
minute. The 2.5 mm hex wrench needed to unscrew the control panel is not included
in standard equipment.
Fig. 2.
Changing the unit of speed
Place the jumper cap in the position
matching to the required unit.
cm
inch
Use the 2.5 mm hex wrench to
loosen the fixing screws to access
the back side of the control panel.
