STARPLUS Triad 1, Product Description Manual

Page: 147 / 496

Executive/Secretary Transfer 5-33
Chapter 5 - Electronic Telephone Operation
Executive/Secretary Transfer
If you are designated the Executive station and your phone is busy or in DND, all calls are
routed to the Secretary station.
If you are the designated Secretary station, you can signal the Executive that is busy or in
DND by using the Camp On feature.
Flash
When connected to an outside line, press the FLASH button to disconnect outside line and
re-seize outside line dial tone.
Flash On Intercom
When connected to a page zone or another internal party, press the FLASH button to
disconnect page or intercom call. An intercom dial tone sounds.
Flexible Button Assignment
If all the buttons on your telephone have NOT been assigned as CO lines, Pooled group, or
LOOP buttons, you may program them to suit your own individual needs. The Flexible Button
Assignment feature also allows flexible button programming from a remote location
(off-site). Range programming can also be used to assign these buttons to multiple stations.
Executive and Enhanced Model Telephones have 22 flexible buttons. Their default button
map is shown in
Figure 5-1: Executive Electronic Key Telephone Default Button Map .
There are 7 possible functions you may assign to these buttons:
1) DSS/BLF -- Pressing this button, automatically signals the assigned intercom station.
DSS/BLF buttons are programmed by the station user.
2) FEATURES -- This button can be programmed so that when pressed it activates a particular
feature, thus eliminating the need for dialing the feature code.
Some features require a flex button to be programmed for that feature to be accessible to the
station user. Where this is the case, it is so designated in this Feature Operation Section and
user guide. Feature buttons are programmed by the station user.
3) LOOP -- This button acts as the direct appearing button for outside lines that do not appear
on the user's individual telephone. Any phone that doesn't have all lines appear on it must
have a loop button. There is NO limit to the number of LOOP buttons a station may have.
4) POOLED GROUP ACCESS -- A group of outside lines can be placed under one button. When
this button is pressed, the system selects an available line from this group for the user to
place a call on.