STACK ST8130 Series Road Car Display SystemsError! Main Document Only.Chapter 5. Installing the Display System
Users Guide
41
For best performance, the following precautions should be
taken:
Bond strength is dependent upon the amount of adhesive to surface
contact development. Firm application pressure develops better adhesive
contact and thus improves bond strength.
To obtain maximum adhesion, the bonding surfaces must be clean, dry
and well unified. Typical surface cleaning solvents are isopropyl
alcohol/water mixture (rubbing alcohol) or heptane. Use proper safety
precautions when handling solvents.
Ideal application temperature range is 21-38ºC (70-100ºF). Initial
application to surfaces at temperatures below 10ºC (50ºF) is not
recommended because the adhesive becomes too firm to adhere readily.
To mount a sensor or housing on the vehicle
Take one of the supplied pieces of 'dual-lock' fastener, remove the
adhesive backing, and attach to the sensor or housing.
Take a second strip of the fastener and attach to the first piece by
pushing them together firmly, ensuring correct alignment.
Remove the adhesive backing off the second strip of fastener and attach
the sensor or housing to the vehicle in the desired position. Push against
the fastener firmly to ensure maximum adhesion.
Do not try to separate the 2 strips of fastener immediately
The acrylic adhesive backing should be given 24 hours to achieve full
bond strength.
If you require further fastener strip, or have any comments, questions, or
recommendations regarding its use, please contact Stack or your nearest
distributor.
