Chapter 3. Operating the Display System
STACK ST8130 Series Road Car Display Systems
12
Users Guide
Parameter
Type of Peak
Value
Gated to RPM
Engine Speed (RPM)
Maximum
No
Oil Temperature
Maximum
Yes
Water Temperature
Maximum
Yes
Oil Pressure
Minimum
Yes
Fuel Level
Value @ Reset
No
Battery Voltage
Minimum
No
Air Temperature
(Ice Warning)
Minimum
No
Wheel Speed
Maximum
No
Displaying the Peak Values
Displaying the Peak Values
Press and hold Switch 1 to show the peak values for the parameters
currently being displayed. Release the switch to return to the normal
display.
Note: The displayed peak fuel level is the value that was current when
the peak values were last reset. The amount of fuel used since the peak
value reset can be calculated by subtracting the current value from the
peak value.
Resetting the Peak Values
Resetting the Peak Values
You can reset all of the peak values manually. All peak values are reset
at the same time. If the engine is running at or above its gate value
when the peak values are reset, they are set to the current value of each
performance parameter.
To reset the peak values:
•
Press and hold Switch 1 to display the peak values.
•
While holding Switch 1, press and hold Switch 4.
•
With Switch 4 held down, you will see the display revert to the
current values. The new peak values that are stored are those being
displayed when you release Switch 4.
